Diffuser Flow Animation
AIR600P · Section A-A at Y = 0 · drawn to scale in mm

How the diffuser spreads the jet

A live cutaway of the AIR600P air and dirt separator with the rev B bidirectional internals. The 6″ jet hits the impingement disc, fills the plenum, and leaves the perforated face plate as an even sheet that crosses the whole Pall ring bed. Switch to the original internals to see the jet punch straight through the middle instead.

Geometry is to scale. Motion is slowed to 26% of real speed so you can follow it, but every speed is scaled by the same factor, so fast and slow parts keep their true ratio. Bubble capture and dirt settling are a simplified illustration of the mechanism, not a measured rating. The magnet pole runs front to back, so this section shows it end-on; the ½″ bleed port is on the dome beside the vent, outside this section.